The Miller Copilot with Auto Deltaweld 350 is an entry - level collaborative welding cell perfect for welders new to robotic welding and experienced ones facing high - mix, low - volume scenarios. It features a 'Headless' power supply design that moves the user interface to the Copilot teach pendant, making operation a breeze. With AccuGuide precision tuning and IntelliSet settings assistant, you can program and weld faster. It's available in air - cooled, and a water - cooled version is coming this summer. The weld ready tool surface is 48 x 48 inches with 5/8 inch tooling holes, compatible with various tools. It's easy to relocate in four steps. It has a full range of capabilities with advanced arc modes. Operator protection is ensured through the cobot's collaborative function. Only minimal assembly is required as it's on caster wheels, and it comes with a video setup guide. Included are Auto - Continuum 350, wire drive motor assembly, Tregaskiss TOUGH GUN CA3 Robotic MIG Gun, integrated welding table, StrongHand Tool Kit, and interconnecting cables.
Using the Miller Copilot with Auto Deltaweld 350 is straightforward. First, assemble the system using the included video setup guide. Mount it on the caster wheels and connect it to power and welding gas. Then, load and unload your workpieces from the single station that can be shared with the robot envelope. Use the Copilot teach pendant to program your welds with the help of the AccuGuide precision tuning and IntelliSet settings assistant. When operating, make sure to wear appropriate personal protection equipment as you'll be working near a live arc. For relocating the workstation, follow the four - step process: disconnect utilities and raise the leveling feet, push it by hand, lower the leveling feet, and reconnect utilities. To keep it in good condition, regularly check the interconnecting cables for any signs of damage. Clean the weld ready tool surface after each use. If you have any issues, refer to the included instructions or contact customer support.
