Product Description
Get the genuine Miller V-Knurl drive roll designed to smoothly feed .030/.035 inch (0.8/0.9 mm) or .045 inch (1.2 mm) flux cored or metal cored welding wires. It's perfect for use with Millermatic 135, 140, 175, 180, 211, Passport, Passport Plus, and Multimatic 200, ensuring reliable welding performance.
Using this Miller V-Knurl drive roll is easy. First, make sure your welding machine is turned off. Then, install the drive roll according to the wire size you're using - either .030/.035 inch or .045 inch. Connect your flux cored or metal cored welding wire to the roll. Once everything is set up, turn on the welding machine and start your welding job. Remember, always wear proper safety gear like gloves and goggles. When you're done, turn off the machine and disconnect the power. To keep the drive roll in good condition, clean it regularly with a soft brush to remove any debris. Also, check for any signs of wear and tear and replace it if needed.
