Miller WC-115A Weld Control w/o Contactor - 137546

The Miller WC-115A weld control runs on 115 VAC. It's mainly for CC DC power sources without a 14-pin. Also works with CV power sources or DC engine drives providing 115 VAC. Note: This control doesn't come with a contactor.

Using the Miller WC - 115A weld control is simple. First, make sure your power source is either a CC DC power source without a 14 - pin, a CV power source, or a DC engine drive that can supply 115 VAC. Then connect the control to the power source. When using it, always check the power supply voltage to avoid any electrical issues. For maintenance, keep it clean and dry. If you notice any problems, stop using it immediately and check for loose connections or signs of damage.