Miller V-Groove Drive Roll .024, .030/.035 Wire - 202925

The Miller Drive Roll 202926, designed for .030 - .045 flux cored wire, features a reversible VK-Groove setup. It's specifically made for small Millermatic MIG and Multiprocess welders, offering great performance for your welding needs.

Using this Miller drive roll is easy. First, make sure your Millermatic MIG or Multiprocess welder is turned off. Then, install the drive roll following the manufacturer's instructions. When welding, choose the appropriate wire size between .030 - .045. Always wear proper safety gear like gloves and goggles. After use, clean the drive roll regularly to keep it in good condition. Store it in a dry place to prevent rust. If you notice any damage, replace the drive roll immediately.