Description
The Miller Electric V Groove drive roll kit (204579) is a great choice for welding. It's designed for feeding 0.030 inch (0.8 mm) and 0.035 inch (0.9 mm) solid or stainless welding wires.
- The V-Groove drive roll is perfect for smooth wire feeding.
- The dual-size and reversible drive rolls have grooves for both 0.030 and 0.035 inches.
- The kit comes with 2 drive rolls and an inlet guide.
- It can be used with Millermatic 200, 210, 212, 250, 251, 252, DVI, Pulser, Vintage, 22, 32, 52, and Suitcase Series or Reach wire feeders.
Accessories
Using this Miller V - Groove drive roll kit is easy. First, make sure your welding machine is turned off. Install the drive rolls into the wire feeder according to the size of the welding wire you'll be using (either 0.030 or 0.035 inches). The inlet guide should be placed at the wire entry point for better wire feeding. When using, keep an eye on the wire feed to ensure it's smooth. After each use, clean the drive rolls with a soft brush to remove any debris. Also, check for any signs of wear on the rolls. If you notice excessive wear, it's time to replace them. Store the kit in a dry place to prevent rusting.
